Configuring G- Only Mode - HP ProCurve 530 NA (J8986A) Management And Configuration Manual

Configuring G- Only Mode

Figure 6-6. Configuring Wi-Fi G-Only Mode
To Configure Wi-Fi G-Only Mode:
This setting, shown in Figure 6-6, allows g-only stations to associate with the
AP. This is Wi-Fi standard-based g-only mode.
Select Network Setup > Radio.
1.
Click Status On to enable the radio.
2.
Select IEEE 802.11g Mode.
3.
Click the Edit button for Advanced Settings. A pop-up window for Advanced
4.
Settings opens (see Figure 6-6).
Select Enable for Protected Mode, to set this radio parameter.
5.
Select rate set values (24, 12, and 6), using the Basic options.
6.
[Update]
7. Select to set the advanced radio parameters.
Wireless Interface Configuration
Configuring the Radio
6-19