configuring the hp wl520
configuring the
configuring the
configuring the hp
in this chapter
in this chapter
in this chapter
in this chapter
Since each network is unique, the WL520 must be configured to operate in your network environment.
Most administrators use the HTTP Interface (web browser) for configuration; however, the Command Line Interface (CLI)
provides the same functionality by entering CLI Commands or scripts from Terminal and Telnet sessions. For information about
using the CLI, please refer to
In some scenarios described in this chapter, you need to make configuration choices (for example, which radio channel to use).
This guide explains each choice. When in doubt, we suggest you accept the default values.
Prerequisites
ScanTool Program
Set Basic Configuration Parameters
Download the Latest Software
–
Setup your TFTP Server
–
Download Updates from your TFTP Server
–
Backup your WL520 Configuration File
–
Copy a Configuration File from Another WL520 Unit
Other Network Settings
–
Configure the WL520 Device as a DHCP Server
–
Maintain 802.11b Client Connections using Link Integrity
Change your Wireless Interface Settings
–
802.11a Wireless Interface Card
–
802.11b Wireless Interface Card
–
Auto Channel Select (ACS)
–
Distance Between APs
–
Multicast Rate
Ethernet Settings
–
Set Ethernet Speed and Transmission Mode
Configure your Management Interfaces
–
Set HTTP Interface Management Services
–
Configure Serial Port Interface Settings
Other Security Configuration Settings
–
Configure your MAC (Address) Access Control Table
–
RADIUS Authentication Settings
–
IEEE 802.1x Security Mode
If You Encounter Problems...
hp wl5
20
hp
wl520
wl520
Using the Command Line
Interface.
2
2 2 2
2-1