Table of Contents
Advertisement
LENNOX HEARTH PRODUCTS • MONTEBELLO
Step 9. INSTALL VOLCANIC STONE, GLOWING EMBERS,
AND LOGS
NOTE: If installing the contemporary burner/floor kit,
skip this step and instead refer to the instructions
provided with the kit.
• DO NOT operate this appliance without the
required accessories properly installed:
—floor (log set or contemporary kit), and
—panels (ceramic or porcelain).
• DO NOT attempt to install the logs until the
appliance installation has been completed, the
gas line connected and tested for leaks and the
initial burner operation has been checked out.
• The size and position of the log set was
engineered to give the appliance a safe, reliable
and attractive flame pattern. Any attempt to
use a different log set in the fireplace will
void the warranty and will result in incomplete
combustion, sooting, and poor flame quality.
• Logs get very hot and will remain hot up to one
hour after gas supply is turned off. Handle only
when logs are cool. Turn off all electricity to
the appliance before you install grate, volcanic
stone, embers and logs.
• This appliance is not designed to burn wood. Any
attempt to do so could cause irreparable damage to
the appliance and prove hazardous to your safety.
• If logs are not installed according to the log
installation instructions, flame impingement and
improper combustion could occur and result in soot
and/or excessive production of carbon monoxide
(CO), a colorless, odorless, toxic gas.
Step 1. Install the ceramic or porcelain panels per the instructions
provided in kit (P/N 506019-91).
Step 2. Place volcanic stone around the burner (the entire bag of
volcanic stone will NOT be used). DO NOT PLACE VOLCANIC
STONE ON THE BURNER. See Figure 32.
Step 3. Separate the glowing embers (rockwool) into pieces about the
size of a quarter (see Figure 33). Keep the pieces fluffed, not
matted. Distribute these pieces over the burner as shown in
Figure 34. Do not use more than is necessary. When properly
positioned, the glowing embers will cover approximately 75%
of the burner.
Step 4. Distribute the platinum embers over the burner as desired. Do
not use more than is necessary.
NOTE: Excessive use of embers may result in sooting or
poor flame. This appliance is provided with enough embers
for several applications, do not use all that is in a new
bag. For best glowing effect, replace the ember material
annually. Replacement volcanic stone, glowing embers,
and platinum embers are available (see Table 18).
22
DLX POWER VENT DV GAS FIREPLACES (MDLX40/45IN-PV) • INSTALLATION INSTRUCTIONS
®
WARNING
WARNING
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Cat. No.
Model
88L53
FGE
80L42
FDVS
H8312
PGE
Table 18: Firebox Accessories
Step 5. Position the individual logs as shown in Figures 36
through 39. Logs should be placed in the order shown. Place
logs 2 and 3 against the pins on the grate, NOT over them.
Proper log and twig placement is critical to encourage
outstanding flame appearance and prevent sooting. When
positioned properly, as shown, twigs will be positioned
between flame peaks and will not impinge any flames.
Volcanic Stone
Figure 32: Volcanic Stone Placement
(MDLX45IN-PV Shown)
Figure 33: Separating Glowing Embers
Glowing Embers (Rockwool)
Figure 34: Glowing Ember Placement
Description
Bag of Glowing Embers
Bag of Volcanic Stone
Bag of Platinum Embers
Advertisement
Table of Contents
