Table of Contents
Advertisement
LENNOX HEARTH PRODUCTS • MONTEBELLO
Step 8. LOG, VOLCANIC STONE, AND GLOWING
EMBER PLACEMENT
NOTE: If installing the Contemporary Burner/Floor
Kit, skip this step and instead refer to the instructions
provided with the kit.
• DO NOT operate this appliance without the
required accessories properly installed:
—floor (log set or contemporary kit), and
—panels (ceramic or porcelain).
• DO NOT attempt to install the logs until the
appliance installation has been completed, the
gas line connected and tested for leaks and the
initial burner operation has been checked out.
• The size and position of the log set was engineered
to give the appliance a safe, reliable and attractive
flame pattern. Any attempt to use a different log
set in the fireplace will void the warranty and will
result in incomplete combustion, sooting, and
poor flame quality.
• Logs get very hot and will remain hot up to one
hour after gas supply is turned off. Handle only
when logs are cool. Turn off all electricity to the
appliance before you install grate, volcanic stone,
embers and logs.
• This appliance is not designed to burn wood. Any
attempt to do so could cause irreparable damage to
the appliance and prove hazardous to your safety.
• If logs are not installed according to the log
installation instructions, flame impingement and
improper combustion could occur and result in soot
and/or excessive production of carbon monoxide
(CO), a colorless, odorless, toxic gas.
Step 1. Install the ceramic or porcelain panels per the instructions
provided in kit (P/N 750182M).
Step 2. Place volcanic stone around the burner (the entire bag of
volcanic stone will NOT be used). DO NOT PLACE VOLCANIC
STONE ON THE BURNER. See Figure 41.
Step 3. Separate the glowing embers (rockwool) into pieces about the
size of a quarter (see Figure 39). Keep the pieces fluffed, not
matted. Distribute these pieces over the burner as shown in
Figure 40. Do not use more than necessary. When properly
positioned, the Glowing Embers will cover approximately 75%
of the burner on natural gas. For propane gas, do not place
embers on main ports.
Note: Excessive use of embers may result in sooting or poor flame.
This appliance is provided with enough Glowing Embers for several
applications, do not feel compelled to use all that is in a new bag. For
best glowing effect, replace the ember material annually. Replacement
Glowing Embers are available (Catalog Number 88L53).
24
DLX DIRECT VENT GAS FIREPLACES (MDLX40/45) • INSTALLATION INSTRUCTIONS
®
WARNING
WARNING
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Step 4. Position the individual logs as shown in Figures 42 through
46. Logs should be placed in the order shown. Place logs 2
and 3 against the pins on the grate, NOT over them.
Proper log and twig placement is critical to encourage
outstanding flame appearance and prevent sooting. When
positioned properly as shown, twigs will be positioned
between flame peaks and will not impinge any flames.
Cat. No.
Model
88L53
FGE
80L42
FDVS
H8312
PGE
Table 10: Firebox Accessories / Parts
Figure 39
For Propane Gas Only: Do Not Place Embers On Main Ports.
Glowing Embers (Rockwool)
Figure 40
Volcanic Stone
Figure 41
Description
Bag of Glowing Embers
Bag of Volcanic Stone
Bag of Platinum Embers
Hide quick links:
Advertisement
Table of Contents
