Lennox Signature Montebello DLX Series Installation Instructions

INSTALLATION INSTRUCTIONS FOR GAS CONVERSION KITS
FOR USE WITH MONTEBELLO
[FIREPLACE MODELS MDLX40, MDLX45]
HOT GLASS WILL CAUSE BURNS.
DO NOT TOUCH GLASS UNTIL COOLED.
NEVER ALLOW CHILDREN TO TOUCH GLASS.
• Install only when fireplace is OFF and COLD.
• Fireplace surfaces get EXTREMELY HOT!
• The glass on the front of the fireplace reaches EXTREMELY HIGH
temperatures and can cause severe burns if touched. Even after
the gas is turned off, fireplace surfaces remain extremely hot.
• Keep children away from an operating fireplace. Closely
supervise children in any room where a fireplace is operating to
prevent contact with glass.
NOTICE
• READ ALL STEPS BEFORE STARTING INSTALLATION.
• LEAVE THESE INSTRUCTIONS WITH THE APPLIANCE.
• All warnings, precautions, and instructions in the Installation
Instructions and Care and Operation Instructions provided with the
appliance also apply to these instructions.
• If you encounter any problems, need clarification of these
instructions, or are not qualified to properly install this kit, contact
your local distributor or dealer.
CAUTION
RISK OF PERSONAL INJURY OR PROPERTY DAMAGE.
• Never operate fireplace without liner panels installed.
• These appliances are NOT approved for operation without
liner panels.
• Do NOT abuse glass doors by striking or slamming shut.
• Never operate fireplace with glass door assembly removed.
• Handle glass door assembly with extreme care. Replace
damaged glass door assembly with approved replacement
assembly only.
• Use only media approved for use with these fireplaces (as
applicable). Failure to use approved media may result in sooting,
delayed ignition, or other improper fireplace operation, and may
void the warranty.
P/N 506019-99
Rev. NC 06/2012
DLX DIRECT-VENT GAS FIREPLACES
®
WARNING
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE
WARNING
This conversion kit shall be installed by a
qualified service agency in accordance with the
manufacturer's instructions and all applicable
codes and requirements of the authority having
jurisdiction. If the information in these instruction
is not followed exactly, a fire, explosion or
production of carbon monoxide may result causing
property damage, personal injury or loss of life.
The qualified service agency is responsible for
the proper installation of this kit. The installation
is not proper and complete until the operation of
the converted appliance is checked as specified
in the manufacturer's instructions supplied with
the kit.The qualified service agency performing
this installation assumes responsibility for
this conversion.
AVERTISSEMENT
Cette trousse de conversion doit être installée
par un technicien agréé, selon les instructions
du fabricant et selon toutes les exigences et tous
les codes pertinents de l'autorité compétente.
Assurez-vous de bien suivre les instructions
dans cette notice pour réduire au minimum le
risque d'incendie, d'explosion ou la production
de monoxyde de carbone pouvant causer des
dommages matériels, des blessures ou la mort. Le
tecnicien agréé est responsable de l'installation
de cette trousse. L'installation n'est pas adéquate
ni complète tant que le bon fonctionnement de
l'appareil converti n'a pas été vérifié selon les
instructions du fabricant fournies avec la trousse.
Le fournisseur de service qualifié ayant réalisé
l'installation assume les responsabilités liées à
la conversion.
HEARTH PRODUCTS
KITS AND ACCESSORIES
GAS CONVERSION KITS
1