Yamaha 01x Service Manual page 15

Escutchen & Contact
1) Installation of Escutchen
a. Place the Escutchen from the above and fit its claw into
the hole in the MLN2 circuit board. (Fig. 2-1)
b. Make sure that the Escutchen is horizontal to the circuit
board and there is no clearance between the Excutchen
and the MLN2 circuit board. (Fig. 2-1)
2) Installation of Upper Contact
Install the upper contact as shown in Fig. 2-2.
3) Installation of Lower Contact
a. Pass the bent part of the lower contact into the clearance
of the upper contact which has already been installed.
(Fig. 2-3)
b. Check to make sure that the contact is horizontal to the
MLN2 circuit board. (Fig. 2-3)
(MLN2 Cicuit Board)
CN1, CN2
MLN2
(Fig. 2-1)
(Fig. 2-2)
(Fig. 2-3)
O1X
15