Needle Position At Straight Stitching - JUKI HZL-27Z Service Manual

Service Manual

6. Needle position at straight stitching

〔Checking〕
Check if the needle point of straight stitching at center needle position comes to the
center of the maximum zigzag bight.
〔Adjustment〕
1. Remove face cover.
2. Insert hex driver (Dia.-2 mm, length- over 100mm) from thread guide plate hole
and turn alignment screw A.
Center needle position is shifted to right.
Center needle position is shifted to left. → Turn it counter clockwise.
Ａ
Attention ： Check "7. M position" after adjustment.
（Notify pinhole on paper for easy
checking ）
→ Turn it clockwise.
When front cover is removed
Original issue
May 2009
Page 11/24
Model
HZL-27Z
Ａ