Presser Foot Height - JUKI HZL-27Z Service Manual

Service Manual

5. Presser foot height

〔Checking〕
1. Raise the presser foot lever.
2. Lower the feed dog below the needle plate.
3. Check and see if clearance between needle plate and presser foot is about 5.5
to 6 mm.
〔Adjustment〕
Remove face cover and raise the presser foot lever.
1.
Loosen screw A of needle bar clamp and adjust the presser foot height by
2.
vertically sliding presser bar.
Tighten screw after adjustment, keeping alignment of the foot with feed dog.
3.
Ａ
Original issue
May 2009
Page 10/24
Model
HZL-27Z
5.5～6 ｍｍ