Frigidaire 27" Dryers with electronic controls Service Manual page 9

QUICK REFERENCE SHEET
2. Touch the start pad and the test will advance to
the HEAT test. (H) will appear in the display, the
drive motor will run and the electric heating element
or gas burner will operate depending on the model.
3. Retouch the start pad and the test will advance to
the AIR FLUFF test. (AF) will appear in the
display and the drive motor will run.
4. Retouch the start pad and the test will advance to
the AUTO DRY MOISTURE COUNTS test. The
AUTO DRY icon will illuminate and a number will
appear in the display. Open the door, place your
hand against the sensor bars and the amount of
the number in the display should go down.
5. Retouch the start pad and the test will advance to
the MEMBRANE test. The display will be blank.
Press each cycle pad and the LEDs should light.
6. Retouch the start pad and the test will advance to
the COOL DOWN test. The COOL DOWN icon will
illuminate and a number will appear in the display
and the drive motor will run.
7. Retouch the start pad and the test will advance to
the TIME DRY test. The TIME DRY icon will
illuminate and a number will appear in the display.
The drive motor will run and the electric heating
element or gas burner will operate depending on the
model.
Press Start to repeat the test. To remove the dryer from
the test mode, disconnect power to the dryer or press
and hold the stop and cycle pads for at least 2 seconds
then release.
9