Air Fluff/No Heat; Dryer Features; Control Lock; Signal - Frigidaire 27" Dryers with electronic controls Service Manual

Gas and electric 27” dryers with electronic controls
Table of Contents

Advertisement

4 minutes as a reminder to remove the load. The dried
load can be removed at any time during Press Saver.
No Heat
This option provides up to 30 minutes of tumbling without
heat and can only be selected in the Timed Dry cycle.
Use it to dry items containing feathers or down, foam
rubber, plastics or similarly textured, rubber-like materi-
als, to freshen clothing, pillows or blankets, or to dust
draperies.

Dryer Features

Control Lock

To prevent accidental operation of the dryer or alteration
of the cycle settings, press and hold the lock symbol until
you hear 3 beeps and "LOC" is displayed. To cancel,
press and hold the lock symbol until "LOC" is no longer
displayed.

Signal

A signal will sound at the end of the cycle and periodically
during Press Saver. Press the signal symbol to select
one of three volume levels or turn off the signal. This
selection will be programmed until you change it.
Timed Dry
Use this feature to manually select the drying time for any
load. Select the temperature desired. You will not be
able to select a cycle or dryness level.
NOTE: Timed Dry is required when using the No
Heat option.
Press TIMED DRY to select 45 minutes of drying time.
The time will increase 5 minutes each time TIMED DRY
is pressed. The maximum drying time is approximately
110 minutes. If you desire less than 45 minutes, you
must advance beyond the 110 minute mark to start again
at 15 minutes.

Error Codes

If the dryer stops and the F 01, F 02, F 03, F 04 or F 05
error code is flashing in the display, press STOP/CLEAR,
select a cycle and press START. If the error code
appears again, call for service to correct the problem.
·
F 01 - There may be an internal problem with the
control.
·
F 02 - There may be a problem with the temperature
sensor.
·
F 03 - There may be a problem with the heater
system.
·
F 04 - The dryer may have run too long. Clean the
lint filter and be sure the vent is not blocked before
calling for service.
·
F 05 - There may be a problem with the keypad.
16

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

27" gas27" electric

Table of Contents