Removing The Console Front Panel With Touch Pad; Removing The Door; Separating The Door Panel; Removing The Door Seal - Frigidaire 27" Dryers with electronic controls Service Manual

Removing the console front panel with touch pad:

1. Disconnect the dryer from electrical supply, and
remove the front panel.
2. Remove the console from the front panel and the drip
rail from the console.
3. Disconnect the ribbon from the control board.
4. Remove the control board and display.
5. Release the 4 lower locking tabs accross the back
of the console holding the plastic front panel to the
metal mounting panel.
6. Pull out on the bottom of the metal panel and slide
the metal panel down to release the top 3 top tabs.

Removing the door:

1. Open the door and remove the four screws holding
Tab

Separating the door panel:

1. Remove the door.
2. Remove the two screws from the end and two
3. Lift the inner panel off the outer panel.

Removing the door seal:

1. The door seal is fasten to the inner door liner by
Tab
60
the door to the hinges.
screws from the bottom.
expandable tabs pushed through slots in the liner.