Section A - Operating Instructions; Before Operating Your Dryer; Operating Steps; Cycle Selection - Frigidaire 27" Dryers with electronic controls Service Manual

SECTION A - OPERATING INSTRUCTIONS

Before Operating Your Dryer

Read your dryer Use and Care Guide. It has impor-
tant safety and warranty information. It also has many
suggestions for best drying results.
To reduce the risk of fire, electric shock
or injury to persons, read the IMPORTANT SAFETY IN-
STRUCTIONS in your dryer Use and Care Guide before
operating this appliance.

Operating Steps

Read "Drying Procedures" in your Use and Care Guide.
It explains these operating steps in detail.
1. Prepare items for drying.
2. Check that lint screen is clean and in place.
3. Load the dryer. If desired, add a dryer fabric softener
sheet. Close the door.
4. Press CYCLES until desired cycle is selected. Suit-
able drying temperature, dryness level and options
will automatically be displayed. To change these
settings, press TEMPS, DRYNESS and OPTIONS
until the desired selections are made. Those adjust-
ments to the cycle will automatically be remembered
each time that cycle is selected.
5. To select or delete Press Saver and Air Fluff/No Heat,
press OPTIONS until the flashing light indicates a
desired option. Then press SELECT to add or delete
the option.
6. If you wish to return to the factory settings, press and
hold "CYCLES" and "OPTIONS" at the same time for
5 seconds and release. The display will show two
dashes for a few seconds indicating that the factory
settings have been selected.
Note: To provide the best care for your laundry
items, not all temperatures, dryness levels
and options are available with all cycles.
7. Add desired features by pressing symbols for
· Control Lock
· End-of-Cycle Signal
· Time Dry
8. Press START to begin cycle.
· To pause the cycle, press STOP/CLEAR
once. "PAU" will flash alternately with the
time remaining display. To resume the cycle,
press START again.
· To stop or clear the cycle, press STOP/
CLEAR twice.
9. A signal will sound near the end of the cycle and
periodically during Press Saver when the signal op-
tion is selected. When the cycle ends, remove items
immediately and hang or fold.
10. Clean lint screen after every load.

Cycle Selection

For best results, follow the fabric care label instructions
on items to be dried.
Auto Dry cycles take the guesswork out of drying time.
The load will automatically be dried at the selected tem-
perature to the desired dryness level. The dryer senses
the moisture level of the load as it tumbles through heated
air. Auto Dry cycles save time and energy and protect
fabrics.
14