Four winns 338 Vista Owner's Manual page 75

Gasoline vapors can explode resulting in injury
or death. Before starting the engine, check
engine compartment bilge for gasoline or
vapors. Operate blower for four minutes, and
verify blower operation. ALWAYS run the
blower when the vessel is operating below
cruising speed.
Cockpit Lights - The COCKPIT LTS switch is used
to activate the cockpit (courtesy) lights. An additional
cockpit light switch is typically located on the cabin
light switch panel.
Horn - To sound the horn, press the HORN switch.
Navigation & Anchor Lights - Moving the NAV/ANC
LTS switch towards the NAV position activates the
bow lights, the all-around light and the instru ment
lights on the dash. Move the switch to the ANC
posi tion to activate the all-around light. The center
switch posi tion is "OFF".
Arch Lights - The ARCH LIGHTS switch is used to
activate the radar arch lights.
Platform Lights - The PLATFORM LIGHTS switch is
used to activate the lights for the swim platform.
Engine Lights - The ENGINE LIGHTS switch is used
to activate the engine lights in the engine compart-
ment.
Trim Tabs - The boat is equipped with electric -
hyd raulic trim tabs, the trim tabs are controlled by the
TRIM TAB switches. Re fer to Section E-8 - Trim Tabs
for more information.
Windlass - The WINDLASS switch activates the
windlass. A circuit breaker is located on the battery
switch panel. Refer to the Section M-11 in this manual
and the manufacturer's literature for additional infor-
mation.
Engine Hatch - The ENGINE HATCH switch is used
to raise and lower the engine lid by activating a linear
screw jack. Pressing the upper portion of the switch
allows the engine lid to be raised. Pressing the lower
portion of switch lowers the engine lid.
Wiper - The WIPER SELECT switch activates the
desired wind shield wiper(s). The wiper(s) will self
park.
Electrical Systems - Section H
B. Installation of Additional 12 Volt Equip ment
Accessories may be added to the boat by wiring
directly to the cabin panel. Non-factory in stalled 12
volt accessory equipment can be con nected to the
"ACC" switch on the dash.
Be sure to provide proper fuse or circuit
break er protection for all 12 volt equip ment that
is installed. DO NOT overload the accessory
circuitry by installing too much additional 12
volt equipment.
C. Interior Equipment
12 volt cabin equipment will be protected by the
12 volt DC system side of the AC/DC cabin panel.
Cabin equipment information is listed as follows:
CO Monitor - The CO monitors are protected by the
12VDC PLUGS circuit breaker in the cabin panel.
Cabin Lights/Night Lights/Berth Lights/Step Lights -
To activate these various lights use the corresponding
"ON/OFF" switch located on the lighting panel.
Additional "ON/OFF" light switches may be located in
various areas of the cabin i.e. forward berthing area.
Forward Bilge Pump - The forward bilge pump can be
activated manually by the FWD BILGE PUMP breaker
switch placed in the "ON" position. This breaker switch
is located on the AC/DC panel.
Any water from the stringers or from other sourc es
within the cabin will drain into the forward bilge
compartment. The pump is equipped with an auto-
matic float switch and will operate when ever bilge
water rises to a level that will cause the float to move
upward. The water will be pumped over board.
Head Compartment Vent/Blower - A blower is in-
stalled in the head compartment. A separate "ON/
OFF" switch is provided in the head com partment.
The head vent is protect ed by a "HEAD LIGHT/HEAD
VENT" circuit breaker on the cabin AC/DC panel.
Pressure Water - A pressure water pump deliv ers
water to the faucets, shower, and transom washd own.
The pressure water pump will oper ate automatical ly
as long as the FRESH WATER circuit breaker switch
is "ON". The circuit breaker is located on the AC/DC
cabin panel. The fresh water pump is protected by a
circuit breaker on the cabin AC/DC panel.
Owner's Manual Page 72