Four winns 338 Vista Owner's Manual page 161

5) Locate the starboard and port side curtains.
6) Zip each partially in place in all directions, then
complete the zipping.
7) Snap to the boat (from the outside if possible).
8) Secure and smooth all velcro closures.
Figure O3: Forward Side Curtain & Visor Installation
NOTICE
The camper canvas has been designed and
are intended to remain installed on the boat in
the upright "stored" position. Four Winns does
not recommend the camper assembly be
removed from the boat unless absolutely
necessary.
NOTICE
Two people are recommended if removal or
installation becomes necessary. Care must be
exercised so the radar arch does not become
damaged. Use a protective covering to prevent
damage to arch if necessary.
NOTICE
In the event the canvas requires some
maintenance or repair, remove the camper
canvas from the bow assembly. Unzip the bow
sleeves, unsnap all snaps and straps, and
remove the canvas.
Weather Covers - Section O
To install the camper canvas:
1) With the long support poles in the back and
the smaller, storage poles in the front (toward the
radar arch), attach the camper top frame to the
side mounts. See Figure O4.
2) Tighten the bolt, first with your fingers and then
with a wrench or other appropriate tool.
3) Release the storage poles and mount them using
the ball and socket provided; secure with the pin.
4) Unzip canvas boot, if necessary.
5) Extend storage poles to reduce tension on the top.
6) Zip the camper top to the camper top valance.
7) Adjust the support poles to create tension
on the top.
8) Center the canvas.
9) Secure and smooth all velcro closures.
camper
top
rear support poles
(adjustable)
side mount
(tighten bolts)
Figure O4: Camper Canvas Installation
To install the camper side & aft curtain:
1) Follow directions for camper top installation
(see previous installation instructions).
2) Starting at the top, start each zipper.
valance
storage poles
Owner's Manual Page 158