View Air
Shutter
Pilot Assembly
Air Shutter
Adjustment Lever
Figure 49
Step 10. HOOD INSTALLATION
The hood is optional for these products. In "Shadow Box" installations, the hood may not be
desired. If the opening above the door is objectionable (as is the case in certain "Flush-Mounted"
installations) the hood may be used.
If desired, install the optional hood. Note the location of the three clips inside the top air channel
above the door. The clips are equally spaced on the top surface of the air channel opening. Use
a screwdriver to open the clips slightly if needed. Engage the back edge of the hood into the clips
to secure.
FINISHING REQUIREMENTS - Wall Details
Complete finished interior wall. To install the appliance facing flush with the finished wall, position
framework to accommodate the thickness of the finished wall (Figure 50).
See Page 5 for Cold Climate Insulation
34
Burner Assembly
Air Shutter
Adjustment Rod
FACTORY SHUTTER OPENING SETTING
Models
SYM-35
Gas Train
Assembly
SYM-40
SYM-45
and Page 8 for Clearances
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
MAIN BURNER
Natural Gas
Propane Gas
Inches (mm)
Inches (mm)
3/16 (4.8)
7/16 (11.1)
3/16 (4.8)
3/8 (9.5)
3/16 (4.8)
3/8 (9.5)
Combustible
Finished Wall
This Area Must Remain
Materials
Clear of Combustible
Materials
Combustible
materials not
allowed below
this point on
the face of the
appliance.
Top of Appliance
Top of Door Frame
Clean Face Models
Figure 50
1" Min
(25 mm)
Spacer