Step.9; Step.10 - Lennox Hearth Products MONTEBELLO LSM40MP-2 Installation Instructions Manual

Direct-vent
Table of Contents

Advertisement

Step 9. INSTALLATION AND REMOVAL
OF GLASS DOOR
WARNING
•.When reinstalling the glass
door, the door latch screws
must be securely tightened
to prevent the glass door
from falling out, which could
potentially cause damage and
possible injury.
• Do not attempt to substitute the
materials used on this door,
or replace cracked or broken
glass.
• Handle this glass with extreme
care! Glass is susceptible to
damage – Do not scratch or
handle roughly while reinstall-
ing the glass door frame.
• The glass door of this appli-
ance must only be replaced
as a complete unit as provided
by the manufacturer. Do not
attempt to replace broken,
cracked or chipped glass sepa-
rately.
• Do not attempt to touch the
front enclosure glass with your
hands while the fireplace is in
use.
WARNING
Do not operate appliance with
the glass front removed, cracked
or broken.
AVERTISSEMENT
Ne pas utiliser l'appareil si le
panneau frontal en verre n'est
pas en place, est craqué ou
brisé.
Only doors certified with the appliance
shall be used.
Seules des portes certifiées pour cet
appareil doivent être utilisées.
CAUTION: DO NOT abuse glass door by
striking or slamming shut.
26
Installing Glass Enclosure Panel
(see Figure 49)
Retrieve. the. glass. door.. Visually. inspect. the.
gasket. on. the. backside. of. the. frame.. Gasket.
surface. must. be. clean,. free. of. irregularities.
and.seated.firmly..
Position.the.door.in.front.of.the.firebox.opening.
with. the. top. of. the. door. held. away. from. the.
fireplace.(Figure 49)...Lower.the.bottom.of.the.
door.assembly.on.the.bottom.door.track.and.
set.on.padded.surface...Pivot.the.door.up.after.
engaging.and.centering.in.the.base.channel.
.
Using. a. Phillips. screwdriver,. fasten. the. door.
frame.to.the.door.latch.with.the.two.(2).screws.. .
The. latch. should. pull. forward. to. engage. the.
door.frame.
Install.the.door.modesty.shield.on.top.flange.
glass.door.as.follows:..grab.the.door.modesty.
shield. with. both. hands,. with. the. open. hem.
going.down.and.engage.it.with.the.upper.lip.
of.the.glass.door.frame.by.pushing.it.all.the.
way.down...Make.sure.the.installed.shield.is.
firmly.in.place.
With.the.firescreen.hanging.on.the.screen.rod,.
insert.the.right.side.of.the.rod.into.the.existing.
hole.on.the.right.modesty.panel...Bend.down.
the.rod.at.the.center.and.drop.the.left.end.into.
the.slot.on.the.left.modesty.panel,.being.careful.
not.to.scratch.the.paint.
Top Flange Glass door
Glass Door Latch (2)
assembly
Screws
Firebox Floor
Glass Door Assembly
INSTALLING THE GLASS DOOR
Figure 49
NOTE:.DIAGRAMS.&.ILLUSTRATIONS.ARE.NOT.TO.SCALE.
Step 10. BURNER ADJUSTMENTS
Flame Appearance and sooting
Proper.flame.appearance.is.a.flame.which.is.
blue.at.the.base.and.becomes.yellowish-orange.
in.the.body.of.the.flame...When.the.appliance.
is.first.lit,.the.entire.flame.may.be.blue.and.will.
gradually.turn.yellowish-orange.during.the.first.
15.minutes.of.operation..After.15.minutes.of.
operation,.if.the.flame.is.blue,.or.if.the.flame.is.
orange.with.evidence.of.sooting.(black.tip),.the.
air.shutter.opening.may.need.to.be.adjusted.
If. the. air. shutter. opening. is. closed. too. far,.
sooting.may.develop..Sooting.is.indicated.by.
black.puffs.developing.at.the.tips.of.very.long.
orange.flames...Sooting.results.in.black.deposits.
forming.on.the.logs,.appliance.inside.surfaces.
and.on.exterior.surfaces.adjacent.to.the.vent.
termination...
Sooting.is.caused.by.incomplete.combustion.in.
the.flames.and.lack.of.combustion.air.entering.
the.air.shutter.opening..To.achieve.a.warm.yel-
lowish-orange.flame.with.an.orange.body.that.
does. not. soot,. the. shutter. opening. must. be.
adjusted.between.these.two.extremes..
Air Shutter Adjustment Guidelines
•. If.there.is.smoke.or.soot.present,.first.check.
the. log. set. positioning. to. ensure. that. the.
flames.are.not.impinging.on.any.of.the.logs.. .
If.the.log.set.is.properly.positioned.and.a.
sooting. condition. still. exists,. then. the. air.
shutter.opening.should.be.increased.
•. The.more.offsets.in.the.vent.system,.the.larger.
the.air.shutter.opening.will.need.to.be.
•. An.appliance.operated.with.the.air.shutter.
opened.too.far,.may.have.flames.that.appear.
blue.and.transparent...These.weak,.blue.and.
transparent.flames.are.termed.anemic..
•. Propane.models.may.exhibit.flames.which.
candle.or.appear.stringy..If.this.is.present.
and.persists,.adjust.the.air.shutter.to.a.more.
closed.position,.then.operate.the.appliance.
for.a.few.more.minutes.to.ensure.that.the.
flame. normalizes. and. the. flames. do. not.
appear.sooty..
The.following.chart.is.provided.to.aid.you.in.
achieving. the. correct. air. shutter. adjustment.
for.your.installation.
Air Shutter Adjustment Guidelines
Amount of
Flame
Primary Air
Color
If air shutter is
Flame will
closed too far
be orange
If air shutter is
Flame will
open too far
be blue
:
Air Shutter
Adjustment
Air shutter
gap should be
increased
Air shutter
gap should be
decreased

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents