Table of Contents
Advertisement
Quick Links
Consumer: Retain This Manual For Future Reference.
In the Commonwealth of Massachusetts:
• Installation must be performed by a licensed plumber or gas fitter
• See Table of Contents for location of additional Commonwealth of
Massachusetts requirements
• Hot! Do not touch! This appliance will be hot during operation and will retain heat for a while after shutting
off the appliance. Severe burns may result.
• Carefully supervise children in the same room as appliance.
• Due to high temperatures, the appliance should be located out of traffic and away from furniture or draperies.
Do not place clothing or other materials on or near this appliance.
• Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage. Refer to this
manual. For assistance or additional information consult a qualified installer, service agency or the gas supplier.
• Do not build a wood fire. Do not burn wood or other material in these appliances.
• This is an unvented gas-fired heater. It uses air (oxygen) from the room in which it is installed. Provisions for adequate
combustion and ventilation air must be provided. Refer to Combustion and Ventilation Air Section.
• This appliance may be installed in an aftermarket, permanently located, manufactured (mobile) home, where not prohibited
by local codes.
• The appliance is only for use with the type of gas indicated on the rating plate. This appliance is not convertible for use
with other gases.
WARNING: If the information in this manual is not followed exactly, a fire or explosion may result causing property
damage, personal injury or loss of life.
FOR YOUR SAFETY
Do not store or use gasoline or other flammable vapors or liquids in the vicinity of this or any other appliance.
WHAT TO DO IF YOU SMELL GAS:
• DO NOT light any appliance.
• DO NOT touch any electrical switches.
• Do not use any phone in your building.
• Immediately call your gas supplier from a neighbor's phone. Follow your gas supplier's instructions.
• If your gas supplier cannot be reached, call the fire department.
Installation and service must be performed by a qualified installer, service agency or the gas supplier.
INSTALLATION AND OPERATION INSTRUCTIONS
Catalytic Vent - Free Wall-Mounted
Fireplace
Model: Scandium-NG
P/N 850,055M Rev. NC, 04/2007
Installer: Leave This Manual With The Appliance.
Report No. :
WARNINGS
Scandium
317-S-05-5
TM
Advertisement
Table of Contents
Related Manuals for Lennox Hearth Products 055M
Summary of Contents for Lennox Hearth Products 055M
- Page 1 • If your gas supplier cannot be reached, call the fire department. Installation and service must be performed by a qualified installer, service agency or the gas supplier. INSTALLATION AND OPERATION INSTRUCTIONS Fireplace Model: Scandium-NG P/N 850,055M Rev. NC, 04/2007 WARNINGS Scandium Report No. : 317-S-05-5...
-
Page 2: Table Of Contents
TABLE OF CONTENTS Section Contents General Information Packaging List Appliance Data Important Safety Information Codes Combustion and Ventilation Air Site Requirements Preparing the Appliance Mounting the Appliance 10.0 Checking the Burner 11.0 Connecting a Gas Line 12.0 Checking the Gas Connections 13.0 Gas Pressure Check 14.0... - Page 3 4.0 IMPORTANT SAFETY INFORMATION (continued) T H E F O L L O W I N G B O X E D I N F O R M AT I O N A P P L I E S T O REQUIREMENTS FOR THE COMMONWEALTH OF MASSACHUSETTS.
-
Page 4: Codes
527 CMR 30 upon sale of the unit. Please refer to section 4.0 on page 2 of this manual. This Lennox Hearth Products unvented gas room heater is certified by OMNI-Test Laboratories, Inc to ANSI Z21.11.2-2007 standard. 6.0 COMBUSTION AND VENTILATION AIR... -
Page 5: Preparing The Appliance
7.0 SITE REQUIREMENTS (continued) Clearances to non-combustibles Non-combustible surfaces are defined as brick, metal, marble, concrete etc. and also a number of man-made materials impervious to flame. If in doubt refer to the material manufacturer for further information before proceeding with installation. Clearances to the sides of the appliance are 4”. -
Page 6: Checking The Burner
9.0 MOUNTING THE APPLIANCE (continued) WARNING THE WALL WHERE THE APPLIANCE IS TO BE INSTALLED MUST BE CAPABLE OF LONG-TERM SUPPORT OF THE TOTAL LOAD OF THE APPLIANCE. MEASURES SHOULD ALSO BE TAKEN TO ENSURE SUFFICIENT STRENGTH TO WITHSTAND THE FORCE OF EARTHQUAKES, VIBRATION AND OTHER EXTERNAL FORCES. -
Page 7: Checking The Gas Connections
Turn on gas supply and test for gas leaks using a gas leak test solution (also referred to as bubble leak solution). NOTE: using a soapy water solution (50% dish soap, 50% water) is an effective leak test solution, but it is not recommended, because the soap residue that is left on the pipes/fittings can result in corrosion over time. -
Page 8: Assembly Of The Glass Facia
15.0 ASSEMBLY OF THE GLASS FACIA - (continued) 2. Slide on the side pieces ensuring that the grille fixing holes (shown) are aligned towards the top of the glass facia (as shown in figure 11). Grille fixing holes Figure 11 3.Ensure the sides are neatly aligned with the glass and secure the sides using two M6 screws for each side as shown in figure 12. -
Page 9: Briefing The Customer
17.0 FITTING THE SIDE PANELS (continued) Insert screwdriver through the holes in the right hand side panel to access the two M6 fixing screws (designated ‘a’ in figure 17) and tighten fully. Next insert two no.8 self tapping screws (designated ‘b’... -
Page 10: Pilot Assembly
21.0 PILOT ASSEMBLY WARNING NO ADJUSTMENTS ARE TO BE MADE TO THE ODS PILOT SYSTEM. TAMPERING WITH THIS SYSTEM CAN BE EXTREMELY HAZARDOUS. Remove the glass facia, glass panel and burner unit (as per servicing section), lint arrestor and pilot unit by using a screwdriver to remove the retaining screws. -
Page 11: Lighting Instructions
IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE. This heater has a pilot which must be lit by hand. When lighting the pilot, follow these instructions exactly. BEFORE OPERATING smell all around the heater area for gas. -
Page 12: Troubleshooting Guide
If you encounter any problems, require spare parts, or have any H6055 questions concerning the installation of the heater please contact your H6059 distributor. For the name of your nearest distributor contact: H6060 H6061 LENNOX HEARTH PRODUCTS H6056 1110 West Taft Avenue H6062 Orange, CA 92865 H6063 Phone: 1-800-9-Lennox H6068 visit us at www.Lennox.com... -
Page 13: Positioning Of Field Assembled Parts
29.0 POSITIONING OF FIELD REMOVABLE PARTS 4 off burner installation positions Figure 21 FAILURE TO POSITION THE PARTS IN ACCORDANCE WITH THESE DIAGRAMS OR FAILURE TO USE ONLY APPROVED WITH THIS HEATER MAY RESULT IN DAMAGE OR PERSONAL INJURY. Figure 21: Removal and refitting of glass door assembly and burner assembly. -
Page 14: Year Limited Warranty
THE WARRANTY Lennox Hearth Products ("LHP") warrants your gas fireplace, appliance, stove or insert ("Product") to be free from defects in materials and workmanship at the time of manufacture. After installation, if any of the components manufactured by LHP in the Product are found to be defective in materials or workmanship during the twenty year warranty period and while the Product remains at the site of the original installation, LHP will, at its option, replace or repair the defective components.