Dodge RAM 1500 User Manual page 159

Programming A Rolling Code
NOTE:
For programming Garage Door Openers that were manufactured after 1995. These
Garage Door Openers can be identified by the "LEARN" or "TRAIN" button located
where the hanging antenna is attached to the Garage Door Opener. It is NOT the
button that is normally used to open and close the door. The name and color of the
button may vary by manufacturer.
1. Place the ignition switch into the ON/RUN position.
2. Place the hand-held transmitter 1 to 3 in (3 to 8 cm) away from the HomeLink
button you wish to program while keeping the HomeLink
3. Simultaneously press and hold both the Homelink
and the hand-held transmitter button.
4. Continue to hold the buttons until the EVIC/DID display changes from "CHANNEL #
TRAINING" to "CHANNEL # TRAINED", then release both buttons.
NOTE:
If the EVIC/DID displays "DID NOT TRAIN" repeat from Step 2.
5. At the garage door opener motor (in the garage), locate the "LEARN" or
"TRAINING" button. This can usually be found where the hanging antenna wire
is attached to the garage door opener motor. Firmly press and release the
"LEARN" or "TRAINING" button.
NOTE:
You have 30 seconds in which to initiate the next step after the LEARN button has
been pressed.
6. Return to the vehicle and press the programmed HomeLink
(holding the button for two seconds each time). The EVIC/DID will display
"CHANNEL # TRANSMIT". If the garage door opener/device activates, program-
ming is complete.
NOTE:
If the device does not activate, press the button a third time (for two seconds) to
complete the training.
7. To program the remaining two HomeLink
remaining button. DO NOT erase the channels.
E L E C T R O N I C S
indicator light in view.
®
button you want to program
®
buttons, repeat each step for each
®
®
button twice
®
157