Table of Contents
Advertisement
SNMP Server
To be notified of SNMP trap events, do the following:
1. Check Enable SNMP Agent.
2. Key in either the IPv4 address or domain name of the computer to be
notified of SNMP trap events.
3. Key in the port number. The valid port range is 1–65535.
Note: The logs that are notified of SNMP trap events are configured on the
Notification Settings page under the Log tab. See Log, page 145 for
details.
Syslog Server
To record all the events that take place on the switch and write them to a
Syslog server, do the following:
1. Check Enable.
2. Key in either the IPv4 address or domain name of the Syslog server.
Key in the port number. The valid port range is 1-65535.
RADIUS Settings
To allow authentication and authorization for the switch through a
RADIUS server, do the following:
1. Check Enable.
2. Fill in the IP addresses and service port numbers for the Preferred and
Alternate RADIUS servers. You can use the IPv4 address, or the
domain name in the IP fields.
3. In the Timeout field, set the time in seconds that the switch waits for a
RADIUS server reply before it times out.
4. In the Retries field, set the number of allowed RADIUS retries.
5. In the Shared Secret field, key in the character string that you want to
use for authentication between the switch and the RADIUS Server. A
minimum of 6 characters is required.
6. On the RADIUS server, Users can be authenticated with any of the
following methods:
Set the entry for the user as su/xxxx
Chapter 6. Device Management
61
Advertisement
Table of Contents
