Commands - Panasonic KX-TG2853BXS Service Manual

12.3.2.2. Batch file Settings
Note:
• "****" varies depending on the country.
• Refer to Commands (P.51) for frequently used commands.

12.4. Commands

Command name
getver Check software version
readid Read ID (RFPI)
bandgap Check VDD adjustment parameter value
bandgap nn Set VDD voltage adjustment parameter value Type "bandgap nn", nn is an adjustment setting value of the bandgap voltage.
conttx Set RFC (burst mode)
setfreq Check frequency adjustment parameter value Type "setfreq", then registered freq adjustment value is read out.
setfreq nn Set frequency adjustment parameter value
eeprom_hs_init Set default data to the EEPROM (handset)
Function
Type "getver", then registered software version is read out.
Type "readid", then registered ID is read out.
Type "bandgap", then registered bandgap adjust value is read out.
Type "conttx", then set RF-burst mode.
Type "setfreq nn", nn is an adjustment setting value of the frequency.
Type "eeprom_hs_init", then default data is registered.
51
KX-TG2853BXS/KX-TG2854BXS/KX-TGA280BXS
Example