The Recall Wizard & Algorithm Filter - TC Electronic System 6000 Basic Operation

SEARCH WIZARD & ALGORITHM FILTER
Introduction
To easily find the perfect preset for your application among
the vast amount of presets available in the System 6000,
we have added a Search-Wizard function. Basically the
Wizard allows you to set up a few criteria and thereby
narrow down the pool of presets to select from. All Reverb
Factory presets are marked with Wizard category-tags.
When storing User presets you can assign a Wizard
category tag yourself to each preset. To further narrow
down your selection you can use the Algorithm Filter. Via
this filter you can select categories or specific algorithms to
select from. Finally you can search on preset names that
includes specific words such as "Hall or Cathedral".
The Wizard is of course 100% non-destructive and
you can at any time press Reset to cancel all Wizard
settings and obtain full access to all presets.
Search "Main-page"
Press Wizard to Press Algo to enter
enter Wizard Algorithm Filter
functions
Preset Name Filter
Search function on
presets names
Preset Name Filter
• Press and a keyboard will pop up.
• Enter any relevant keyword (e.g. "arena") - and only
presets with names containing "arena" will be listed.
The hierarchy of the Algorithm Filter and Wizard:
1 Wizard
2
Preset Name Filter
3 Algorithm Filter
8
Press Reset to
reset all Wizard
settings
Applies specifically for
Reverb presets
Applies for all preset
types
The Wizard
To access; press the Wizard tab on the Wizard "main-page".
Mode
Enable Wizard
Press to enable the Wizard.
Wizard Category
Select which main categories you would like to select
presets from. Options are: Music-Reverb or Film-Reverb.
Show Factory - Show User
Select whether you wish to be able to recall from either
Factory or User preset banks or from both.
Engine Output Format
Press Output Format to activate the Output format filter.
Then specify which Output format the presets you are
searching for should have.
Options are Mono/Stereo or Multichannel or both.
Now go to the Type page and select Wizard tags.
(see next page)