Smpte; Midi - TC Electronic System 6000 Basic Operation

SMPTE

Basic Operation
• Press parameter to select and use Fader 6 to set value.
Reader Enabled
On/Off switch for the System 6000 SMPTE Reader.
Frame Rate
Range: 24 FPS, 25 FPS, 29.97 FPS,
30 Drop FPS, 30 FPS.
Running Status
The small field in the top left corner of the numeric display
will state "Running" when SMPTE clock is running.
MIDI Setup Page
Introduction
MIDI Channels
To recall presets for Scene, Routing and Engines 1 to 4
you must first setup individual MIDI channels for these
categories.
In the example above we have setup MIDI channels 1 to 4
for Engines 1 to 4 respectively; channel 5 to access Scene
presets and channel 6 to access Routing presets.
14
FRAME - SYSTEM - MAIN
Bank Mode
The Bank mode settings determine the destination bank of
the received program change on the specified MIDI
channels.
Normal mode:
This mode requires that the external sending MIDI device
can send both Controller 0 and 32 in addition to MIDI
program changes. This is an essential feature to recall
presets from a device holding more than 128 preset
location. (see table in next column for details)
Factory and User mode:
These modes will force any incoming program change to
access either Factory or User banks directly and are
typically used if your sending MIDI device cannot send
Controllers 0 and 32 as described above.
Normal mode
In Normal mode all banks can be accessed for program
changes. Bank selection is done via Ctrl 0 (MSB) and
Ctrl 32 (LSB):
• Controller 0 must be set to 0 in all cases.
• Controller 32 value must match the bank number you
wish to address according to the table below.
Ctrl 32 value 0 - F1:
Ctrl 32 value 1 - F2:
Ctrl 32 value 2 - F3:
Ctrl 32 value 3 - F4:
Ctrl 32 value 4 - F5:
Ctrl 32 value 5 - F6:
Ctrl 32 value 6 - F7:
Ctrl 32 value 7 - F8:
Ctrl 32 value 8 - F9:
Ctrl 32 value 9 - F10:
Ctrl 32 value 10 - F11:
Ctrl 32 value 11 - F12:
Ctrl 32 value 12 - F13:
Ctrl 32 value 13 - F14:
Ctrl 32 value 32 -
Ctrl 32 value 64 -
Ctrl 32 value 65 -
Ctrl 32 value 66 -
- - - -
Ctrl 32 value 73 -
Example:
You wish to recall preset 10 from the Reverb (Music
Surround) bank. According to the table above:
• Set Ctrl 0 to "0" and Ctrl 32 to "2" and send program
change no 10.
SysEx Device ID
Range: 0 to 126
Select SysEx ID for the Mainframe.
Reverb A (Music Stereo)
Reverb B (Music Stereo)
Reverb (Music Surround)
Reserved
Reverb A (Film Stereo)
Reverb B (Film Stereo)
Reserved
Reverb (Film Surround)
Reserved
Mastering
Reserved
Pitch & Delay
Reserved
M5000 Presets
User bank
Card Bank 1
Card Bank 2
Card Bank 3
-
Card Bank 10