Table of Contents
Advertisement
Glass Information
Only glass approved by CFM Specialty
Home Products should be used on this
fireplace.
•
The use of any non-approved replacement glass will
void all product warranties.
•
Care must be taken to avoid breakage of the glass.
•
Do not operate appliance with glass front
removed, cracked or broken.
•
A replacement glass frame assembly (complete
with gasket) is available through your CFM
Specialty Home Products dealer and should only
be installed by a licensed qualified service
person.
Glass Frame Assembly Removal
1. Turn the fireplace OFF (including the pilot).
2. If the unit has been operating allow time for the
components to cool.
3. Using a Phillips screwdriver, unfasten two (2) screws
located at the top of the glass frame. (Fig. 36)
4. Tilt the glass frame at the top away from the unit. Lift
it carefully off the bottom door track and set on
padded surface.
Fig. 36 Remove Phillips screws, tilt frame forward and lift
off bottom door track.
20007172
Operating Instructions
Phillips
Screws
FP1469
Chateau
Decorative Gas Appliance
™
Glass Cleaning
It is necessary to periodically clean the glass. During
start-up, condensation, which is normal, forms on the
inside of the glass. This condensation causes lint, dust
and other airborne particles to cling to the glass
surface.
Also initial paint curing may deposit a slight film on the
glass. It is therefore recommended the glass be
cleaned two or three times with a non-ammonia based
household cleaner and warm water (gas fireplace glass
cleaner is recommended) within the first few weeks of
operation.
After the initial cleaning process the glass should be
cleaned two or three times during each operating
season depending on the environment in the house.
Clean the glass after the first two weeks
of operation.
Restrictor Plates Installation
Refer to Page 12 for your venting configuration and
combination of restrictor plate requirement.
Restrictor Plate Installation
Using the two (2) screws provided along with the
restictor plate shipped with the logset, fasten the
restrictor plate to the firebox top through the front of
the unit. (Fig. 37)
FP1364
Fig. 37 Restrictor plate location.
Flue Opening
Restric-
tor Plate
Sheet Metal
Screws
DVT38S2
Use tin snips to cut
along slots to make 4¹⁄₂"
(114mm) restrictor plate.
(Refer to Page 18, Fig.
29)
21
Hide quick links:
Advertisement
Table of Contents
