Jabra GO 6470 User Manual page 24

CONNECT DESK PHONE
Figure 21: Connect to the handset port
GN1000
Mount and configure
GN1000 on desk phone.
Follow the instructions in
GN1000 manual
Figure 23: Mount and configure on the desk phone
If the handset was not lifted, touch No. In this case, you can choose to Retry or Cancel. If you choose to retry, the
touchscreen takes you back to a point in this flow just after step1 (where Jabra Gn1000 has been selected). If you
choose to cancel, the setup is aborted and the touchscreen takes you to the start of the cabling procedure for
configuration without ehs or Gn1000. you can return to the Gn1000 setup later.
GN1000
Check GN1000 manual to
adjust ring detector
Figure 25: Adjust the ring detector
the wizard now leads you through the clear dial-tone and mic. level configuration. see the section "Configuring
the Jabra Go Base for your Desk Phone" for more.
5. In the CON-
NECT DESK
PHONE
screen, shown
left, connect
to the handset
port.
Figure 22: Connect control cable to AuX port on the base
7. In the (first)
GN1000
screen, shown
Did the GN1000 lift the
left, mount
handset successfully?
and configure
the Gn1000
on the desk
phone.
Figure 24: touch Yes if the handset was lifted
9. In the (third)
GN1000
screen, shown
Congratulations, GN1000
left, check the
installation complete
Gn1000 manual
to adjust the
ring detector.
Figure 26: A successful setup
Jabra GO 6470 User manUal
CONNECT
GN1000
Yes No
GN1000
6. In the (second)
CONNECT
screen, shown
left, connect
the control
cable attached
to the Gn1000
to the base's
aUX port.
8. In the (second)
GN1000
screen, shown
left, you must
determine
whether the
desk phone
went off-hook.
If so, touch Yes.
10. the (fourth)
GN1000 screen,
shown left,
lets you know
that the setup
is completed
successfully. Just
go to the next
screen.
24