Stock Guide Assembly And Positioning - Delta 43-290C Instruction Manual

Stock Guide Assembly and Positioning

Figure 14
Slide two guide brackets (A) onto a guide assembly rod (B).
Thread two allen lock screws(C) into threaded holes on guide
brackets and hand tighten.
Figure 15
Insert stock guide rod (A) thru hole in fence bracket (B).
Thread an allen lock screw (C) into top of fence bracket
and tighten with adjusting hex wrench.
Figure 16
Loosen the two allen lock screws (A), slide spring bars (B)
under bracket lock screws and over guide rod. Position the
guide spring bars and guide brackets, then tighten lock
screws with adjusting hex wrench.
Figure 17
Assemble the remaining stock guide in the same manner.
This view shows the complete stock guide assembly set-
up for a typical operation.
9
Fig. 14
Fig. 15
Fig. 16
Fig. 17