Table of Contents
Advertisement
2001 Windstar Workshop Manual
Visual Inspection Chart
Mechanical
Washer fluid level
Central junction box (CJB) fuse(s):
Fuel tank
Engine coolant level
Accessory drive belt
Engine oil level
Brake fluid level
Battery junction box (BJB) fuse(s):
Circuitry
Loose or corroded connectors
Switches or sensors
3. If the inspection reveals obvious concern(s) that can be readily identified, repair as necessary.
4. If the concern remains after the inspection, connect the diagnostic tool to the data link connector (DLC) located beneath the instrument panel and select the vehicle to be tested
from the diagnostic tool menu. If the diagnostic tool does not communicate with the vehicle:
check that the program card is correctly installed.
check the connections to the vehicle.
check the ignition switch position.
5. If the diagnostic tool still does not communicate with the vehicle, refer to the diagnostic tool manual.
6. Carry out the DATA LINK DIAGNOSTIC TEST. If the diagnostic tool responds with:
CKT914, CKT915 or CKT70 = ALL ECUS NO RESP/NOT EQUIP, refer
NO RESP/NOT EQUIP for instrument cluster (IC), refer
NO RESP/NOT EQUIP for message center module (MCM), front electronic module (FEM), or rear electronic module (REM), refer
SYSTEM PASSED, retrieve and record the continuous diagnostic trouble codes (DTCs), erase the continuous DTCs and carry out self-test diagnostics for the instrument
cluster.
7. If the DTCs retrieved are related to the concern, go to the Message Center Module Diagnostic Trouble Code (DTC) Index or the Instrument Cluster Diagnostic Trouble Code (DTC)
Index to continue diagnostics.
8. If no DTCs related to the concern are retrieved, proceed to the Symptom Chart to continue diagnostics.
Message Center Module Diagnostic Trouble Code (DTC) Index
DTC
Description
B1205 EIC Switch 1 Assembly Circuit Failure
B1676 Battery Voltage Out of Range
U2013 Compass Module — No Response
Note: For a complete master list of all MCM DTCs, refer
Instrument Cluster Diagnostic Trouble Code (DTC) Index
Scan Tool Displayed DTC Dealer Test Mode Displayed DTC
U1041
U1073
U1123
U2013
Note: For a complete master list of all instrument cluster DTCs, refer
FEM Diagnostic Trouble Code (DTC) Index
DTC
Description
B1254 Air Temperature External Sensor Circuit Failure
Note: For a complete master list of all FEM DTCs, refer
REM Diagnostic Trouble Code (DTC) Index
DTC
Description
B2570 Right Lamp Outage Signal Circuit Short to Ground
B2571 Left Lamp Outage Signal Circuit Short to Ground
Note: For a complete master list of all REM DTCs, refer
http://www.fordtechservice.dealerconnection.com/pubs/content/...
Electrical
28 (10A)
14 (10A)
10 (5A)
16 (10A)
9 (10A)
2 (10A)
13 (10A)
toSection
toSection
413-01.
Source
Action
MCM
GO to
Pinpoint Test
D.
MCM
GO to
Pinpoint Test
A.
MCM
GO to
Pinpoint Test
B.
toSection
419-10.
D141
SCP (J1850) Invalid or Missing Data for Vehicle Speed
D073
SCP (J1850) Invalid or Missing Data for Engine Coolant
D123
SCP (J1850) Invalid or Missing Data for Odometer
D013
Compass Module — No Response
toSection
419-10.
Source
Action
FEM
GO to
Pinpoint Test
E.
toSection
419-10.
Source
Action
REM
GO to
Pinpoint Test
REM
GO to
Pinpoint Test
toSection
419-10.
418-00.
Description
Source
PCM
CARRY OUT the PCM self-test.
PCM
CARRY OUT the PCM self-test.
ABS/TC CARRY OUT the ABS/TC self-test.
ICM
GO to
G.
G.
Page 3 of 12
toSection
419-10.
Action
Pinpoint Test
D.
11/30/2009
Advertisement
Table of Contents
