Camera Input/Output Port And Events; I/O Setup - JVC VR-N900U Instructions Manual

Camera Input/Output Port
and Events
The input/output port is the input/output terminal which is
equipped in each device that is registered to VR-N900U.
The input port as can be registered as "Input Event" and for
the output port as "Output" can be registered. As for the
registered input/output port, it is associated with the
following explanation and which can be linked to this event.
☞
( "Specifying an Output Port" Page 53)
The event is utilized in order to start recording, transmit E-
mail, move the PTZ camera to preset position, and to control
the output port of the device. The event is divided into 4
types as described below.
■ Input events: The input signal of the sensor connected to
the input port of the device can be registered as "Input
Event".
■ Generic events: It registers as the generic event.
■ VMD (Video Motion Detection) events: It registers the
motion detection of image as the VMD event.
■ Event buttons: Events generated manually by clicking buttons.

I/O Setup

1
Click the [I/O Setup] button in the [Camera
Record Setting] window.
• This will open the [I/O Setup] window.
• The [I/O Setup] window lets you add input events, VMD
events and outputs that can be used for the network
cameras.
[I/O Setup] window
Add new event:
Used for defining input events on the device selected in
the [Defined events] list. Depending on the type of device,
you may be able to define one or more input events on the
device.
When you click the plus sign next to the device in the
[Defined events] list, and select a defined input event, the
[Add new event] button becomes available for defining
☞
timer events. ( Page 49)
Add new output event:
Opens the [Add New Output] window. (
☞
Page 49)
Add VMD Event (Motion Detection):
Lets you add a VMD (Video Motion Detection) event to the
device selected in the [Defined Events] list. Only one VMD
event can be defined per camera.
CAUTION
• In order to avoid the risk of an excessively high number of
VMD events being generated, a VMD event cannot occur
more frequently than every five seconds.
• VMD events cannot be sent by e-mail.
Edit selected:
Lets you edit the settings for an item selected in the
[Defined events] list.
Remove selected:
Lets you remove an event selected in the [Defined events]
list.
Advanced:
Opens the [Advanced] window. (
CAUTION
• The available events differ for each network camera.
Specify an input event
1
Select the required camera from the [Enabled
Input Event(s)] list in the [I/O Setup] window.
[I/O Setup] window
2
Click the [Add new event] button.
The [Multiple Input Events] window will appear.
[Multiple Input Events] window
☞
Page 50)
47