Edit To Or From Another Recorder - JVC ShowView LPT0923-001A Instructions Manual

EDITING
60
EN

Edit To Or From Another Recorder

You can use your unit as the source player or as the recording
deck.
NOTE:
When using another recorder as the recording deck, refer to its
instruction manual.
A When using your unit as the source player:
TV receiver
Player
21-pin SCART cable
(not provided)
Recorder
B When using your unit as the recording deck:
TV receiver
Recorder
21-pin SCART cable
(not provided)
Player
Your unit
21-pin SCART cable
(provided)
Another recorder
Your unit
21-pin SCART cable
(provided)
Another recorder
Slide the TV/CABLE/SAT/DVD switch to DVD.
1
Connect another recorder's 21-pin SCART connector to the
unit's 21-pin SCART connector as illustrated.
A When using your unit as the source player:
— connect its L-1 IN/OUT connector to the recording deck.
B When using your unit as the recording deck:
— connect its L-2 IN/DECODER connector to the source
player.
If another recorder is compatible with the Y/C signal:
— when using your unit as the source player, set "L-1 OUTPUT" to
"SCART S-VIDEO". ( pg. 61)
— when using your unit as the recording deck, set "L-2 SELECT" to
"S-VIDEO". ( pg. 61)
2
When using this unit as the recording deck, press HDD or DVD
to select the recording deck.
3
When using this unit as the recording deck, press PR +/– to
select "L-2".
Set "L-2 SELECT" to "VIDEO" or "S-VIDEO". (
4
When using this unit as the recording deck, press REC MODE
repeatedly to set the recording mode.
5
Engage the Play mode of the source player.
6
Engage the Record mode of the recording deck.
7
Stop recording on the recording deck, then stop playback on the
source player.
NOTES:
All necessary cables can be obtained from your dealer.
For Y/C signal input/output, be sure to use a 21-pin SCART cable
that is compatible with the Y/C signal.
When you use this unit as the source player for editing, be sure to set
"SUPERIMPOSE" to "OFF" before starting. (
If you are using another recorder with S-Video and Audio output
connectors, connect its S-Video and Audio output connectors to this
unit's S-VIDEO and AUDIO input connectors on the front panel.
Then, set the unit's input mode to "F-1" in step 3, and set "F-1 INPUT"
to "S-VIDEO". ( pg. 62)
pg. 61)
pg. 69)