Table of Contents
Advertisement
CHAPTER 2. ADJUSTMENTS, PERFORMANCE CHECK, AND FIRMWARE UPGRADE
SPST (SHARP Program Support Tool) allows you to adjust settings, conduct performance checks, and upgrade the firmware.
[1] SHARP PROGRAM SUPPORT TOOL (SPST)
1. SYSTEM REQUIREMENTS
• IBM PC compatible personal computer (standard COM1 115,200 bps
serial port and USB required)
Supported OS: Windows 98/98SE/2000/XP
(except for Windows 95/ME/NT)
(English, German, Italian, Spanish, French and Chinese versions)
• Data cable
<During RF adjustment>
• GSM tester: CMU200
• GPIB interface: National Instruments USB-GPIB cable
(Model No.: NI GPIB-USB-B)
2. INTRODUCTION
2-1. FUNCTIONS
SPST offers seven key functions:
1) Firmware download
2) User data transfer (processes all data at once but not individually.)
3) RF calibration check and test
4) Default setting
5) Identification
6) Performance check and adjustment
7) User password reset
2-2. INSTALLATION
1. Use Windows Explorer to execute the "setup.exe" file on the CD-
ROM.
2. The SPST TM150 setup wizard appears. Follow the installation
instructions.
3. After the installation is complete, shortcuts to SPST are created on
the desktop and under the "Start"-"Programs"-"TM150" menu.
Start SPST from the shortcuts.
2-3. STARTING UP
Connect TM150 to an operable serial port of the PC with the supplied
data cable. Make sure that the battery is fully charged.
Start SPST from the desktop.
1. The Input password dialog box appears. Enter the password, select
a port where TM150 is connected from the list box, and click "OK".
If you do not know SPC, click "Cancel" to exit.
CONFIDENTIAL
TM150 ADJUSTMENTS, PERFORMANCE CHECK, AND FIRMWARE UPGRADE
2 – 1
DRAFT
2. To change the password, enter the current password in procedure 1,
and then click "Change Password".
3. To check the usage status of tools, click "Show Repair Log" in procedure 1.
4. Click "Downloader for Emergency".
The above screen appears. Select a model to use and execute the
Downloader. (Use this to initialize the flash, etc.)
5. When the password is correct, a connection is established and the
following screen appears.
Refer to the attachment 1
for the destination and
operator name.
TM150
Software version:
A02-006-0138-TM150
Advertisement
Table of Contents
