JVC SR-MV30 Instructions Manual page 82

TROUBLESHOOTING
82
EN
Playback (VCR Deck)
The VCR deck can not be operated.
The VCR deck is not selected.
]Press VCR/DVD repeatedly so that the VCR lamp lights up on
the unit.
The tape will not rewind or fast-forward.
The tape is already fully rewound or fast-forwarded.
]Check the cassette.
The playback picture does not appear while the tape is running.
The TV receiver's channel selector is not set to the video
channel.
]If you are using the RF connection, set the TV receiver to the
video channel.
]If you are using the AV or S-Video connection, the TV receiver is
not set to the AV mode.
The unit's video channel has not been correctly set.
]Perform the video channel set. (
Noise appears during visual search.
This is normal.
Noise appears during normal playback.
The automatic tracking mode is engaged.
]Try manual tracking. (
The playback picture is blurred or interrupted while TV
broadcasts are clear or "USE CLEANING CASSETTE" message
appears on the screen.
The video heads may be dirty.
]Use a dry cleaning cassette ECL-3F, or consult your JVC dealer.
Breaks are noticeable in Hi-Fi soundtrack.
The automatic tracking mode is engaged.
]Try manual tracking. (
Recording (DVD Deck)
The desired program cannot be recorded.
The channel position does not correspond to that in the
receiving area.
]Set the correct channel position for the receiving broadcast.
( pg. 21)
Recording cannot be made.
No disc or a disc not being compatible with the unit is loaded.
]Load a recordable disc on the unit. (
The disc loaded is not formatted.
]Format the disc. ( pg. 78)
A finalized DVD-R disc is loaded.
]Recording cannot be made on finalized discs. Load a recordable
disc on the unit.
The disc is full or does not have enough space for the program
to be recorded.
]Clear unnecessary programs on the disc or load a blank disc.
( pg. 57)
pg. 17)
pg. 49)
pg. 49)
pg. 8)
Recording (VCR Deck)
During recording, the tape does not run. The VCR recording lamp
lights up on the front display panel.
The unit is in the Record Pause mode.
Press 4 to resume recording.
Recording cannot be made.
There is no cassette loaded, or the cassette loaded has had its
record safety tab removed.
]Insert a cassette, or using adhesive tape, cover the hole where
the tab was removed.
TV broadcasts cannot be recorded.
"L-1" or "F-1" has been selected as the input mode.
]Set to the desired channel.
Camcorder recording is not possible.
The camcorder has not been properly connected.
]Confirm that the camcorder is properly connected.
The input mode is not correct.
]Set the input mode to "F-1".
The tape is automatically rewound, then the unit is shut off.
The end of the tape was reached during recording.
]The program may not have been recorded in its entirety. Next
time make sure you have enough time on the tape to record the
entire program.