Table of Contents
Advertisement
Each key has a different function, illustrated by a directional arrow just above and to the left of the key.
Up
From left to right, the first key is the Up key. The next key is the Down key. The third key is the Back key. And, the last key,
the key on the right, is the Enter key. Follow the steps below to enter the addresses:
1.
Press the Enter key. The LCD Panel will display the message Network Setup...
2.
Press the Enter key. The Panel displays the IP Address entry screen. The cursor will be positioned at the location of
the first digit in the first set of numbers. Use the Up and Down arrow keys (Up increments the number, Down
decrements it) to locate the first number in the IP address. When the correct number is displayed in the first position,
depress the Enter key. The cursor advances to the next position in the IP address. Continue to use the Up and Down
arrow keys to locate the numbers in the IP address, depressing the Enter key to accept each number. Use the Back
key to move the cursor one position to the left. Don't forget, if the address you were given has only one or two digits
in any of the number sets of the address, use leading zeroes to pad the number set to three digits. For example, if the
IP address you were given is 195.182.30.4, enter 195.182.030.004 in the address fields. When you have finished and
have verified that you entered the correct IP address, press the Enter key.
3.
The Subnet Mask entry screen displays. Enter the Subnet Mask using the arrow keys as you did for the IP address.
When you have finished, press the Enter key.
4.
The Default Gateway address entry screen displays. Enter the address and press the Enter key.
Page 17 of 98
VR-N100U USERS MANUAL
Down
Back
All Items Are Subject To Change Without Notice
Enter
Feb. 2004 Rev 1.0
Advertisement
Table of Contents
