Installation Sequence - Danfoss TripleLynx CN Installation Manual

2. Introduction
Product Label
2
Illustration 2.2: Product Label

2.1.1. Installation Sequence

1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
6
Read the installation manual. Pay special attention to the section
formation .
Install the inverter according to the section
Mounting the Inverter .
the section
Open the inverter according to the section
Install AC according to the section
Install PV. Remember to use the terminal block to establish parallel connection (if re-
quired), as described in the section
Install Auxiliary input according to the section
Close the inverter according to the section
Turn on AC at the mains switch.
Set language, time, date, installed PV power and country:
- For setup via the integrated Web Server, see the TripleLynx CN User Manual,
Quick Guide section
Web Server
- For setup via the display, see the section
this manual.
Turn on PV by turning the PV load switch on.
Verify the installation by comparing with the auto-detection result in the display, as de-
PV Connection .
scribed in the section
The inverter is now ready for operation.
The product label on the side of the inverter
shows:
• Inverter type
• Important specifications
• Serial number, see (1), for identifi-
cation by Danfoss
Installation Dimensions and Patterns and
Opening and Closing the Inverter .
AC Grid Connection .
PV Connection . The inverter has auto-detection.
Connection of Peripheral Units .
Opening and Closing the Inverter .
Start-up and Check of Settings in
L00410580-01_02
Important Safety In-