Table of Contents
Advertisement
To connect to an amplifier/receiver equipped with 5.1-channel inputs
The unit supports the linear PCM multichannel format of DVD AUDIO and can feed multichannel audio output signals
from the six analog AUDIO OUT jacks.
It is also equipped with the DTS and Dolby Digital decoders. So you can enjoy any type of the high quality surround
sounds by connecting the unit to an amplifier/receiver equipped with the 5.1-channel inputs of an amplifier or receiver
using the supplied audio cables.
The unit
AUDIO OUT
COAXIAL
SUBWOOFER
LEFT
CENTER
RIGHT
REAR
FRONT
Red
White
Red
Red
White
Yellow
• Be sure to connect correctly between corresponding terminals. The order of the 5.1-channel terminals depend on units.
NOTE
• When using the 5.1-channel outputs of the unit, set the [ANALOG OUT] in the [AUDIO] preference display to [MULTI
CHANNEL] (see page 60). If you select [EXPERT] in the [SPK.SETTING] preference display, you can control the audio output
balance of the speakers (see page 61).
DIGITAL OUT
VIDEO OUT
VIDEO
VIDEO SIGNAL SELECTOR
PCM / STREAM
COMPONENT
OPTICAL
PAL
COMPONENT
VIDEO
COMP.
/S-VIDEO
Y
P
P
B
R
Y/C
REMOTE
/RGB
/AV OUT
NTSC
PAL
S-VIDEO
White
Audio/video cable
(supplied)
Audio cable (supplied)
Audio cable (supplied)
AV OUT
AV COMPU LINK
Amplifier or receiver
FRONT
White
Yellow
Red
REAR
White
Red
CENTER
White
SUBWOOFER
Red
Getting started
AUDIO IN
LEFT
RIGHT
LEFT
RIGHT
11
Advertisement
Table of Contents
