Factory Five Racing Type 65 Coupe Assembly Manual page 186

Run the brake line up the back of the 2"x 3" tube.

At this point your routing will depend on your rear brakes. 87-95 Mustang solid axles have a
single flex line that runs to the middle of the axle then out to the calipers. Newer axles and the
FFR rear brakes run the flexible brake lines direct from the chassis to the caliper (the IRS is done
like this, there is an extra length of line and a T to allow similar routing to the front.)
If using the 87-95 Mustang mount, drill two holes for the Mustang brake bracket on the underside of the
2"x 3" frame member and mount the Mustang bracket.
Attach the brake line to the Mustang mount.
Using the FFR rear brakes, we attached the flexible brake line mount to the driver side diagonal ¾" tube
with the brake line clip.
185
www.factoryfive.com 508-291-3443