Maintenance: Laying up and launching
Bringing out of storage
Check oil level in the engine and drive/reverse
●
gear. Top up if necessary. If there is inhibiting oil
in the system drain and fill with new oil, change oil
filter. For correct oil grade: See the chapter "Tech-
nical Data".
Drain the antifreeze from the seawater system.
●
Install the impeller in the seawater pump (replace
●
if the old one looks worn).
Close/tighten drain cocks/plugs.
●
Check drive belts.
●
Check the condition of rubber hoses and tighten
●
hose clamps.
Check engine coolant level and antifreeze protec-
●
tion. Top up if necessary.
Connect the fully charged batteries.
●
60
Paint the drive and hull: See next page.
●
Check the sacrificial anode on the drive. If there
●
is less than 50% of the anode left it must be
replaced. Clean with emery cloth just before the
boat is launched.
IMPORTANT! Do not use a wire brush or other
steel tools when cleaning, as these may dam-
age the galvanic protection.
Reinstall the propeller.
●
Launch the boat. Check for leaks.
●
Vent and lubricate the propeller shaft seal (reverse
●
gear).
Start the engine. Check that there are no fuel,
●
engine coolant or exhaust gas leaks and that all
control functions are operating.