Maintenance; Engine, General - Volvo Penta D2 Series Operator's Manual

Maintenance

This chapter contains instructions regarding how the above maintenance points should be carried out together
with general technical information. Read the instructions carefully before starting work. Maintenance intervals
are contained in the chapter above. Maintenance schedule
WARNING! Read the safety precautions for maintenance and service in the chapter: Safety Precautions,
before starting work.
WARNING! Unless otherwise specified all maintenance and service must be carried out with the engine
stopped. Stop the engine before opening or removing engine hatches. Immobilize the engine by removing
the ignition key, turning off the power supply with the main switch.

Engine, general

36
General inspection
Make a habit of "visually" inspecting the engine and
engine room before starting the engine and after
stopping when the engine has been turned off. This
will help you to quickly detect abnormalities that have
occurred or are about to occur.
Look especially carefully for oil, fuel and coolant
leaks, loose bolts, worn or slack drive belts, loose
connections, damaged hoses and electric cables.
This inspection takes only a few minutes but can
prevent serious operating diesturbances and costly
repairs.
WARNING! Accumulations of fuel, oil and
grease on the engine or in the engine room is a
fire hazard and must be removed immediately
they are detected.
IMPORTANT! If an oil, fuel or coolant leak is de-
tected, the cause must be investigated and the
fault rectified before the engine is started.
IMPORTANT! Never point high-pressure water
jets directly at seals, rubber hoses or electrical
components. Never use the high-pressure func-
tion when washing the engine.