Table of Contents
Advertisement
Alarm out
SeaNet-Alarm has a detatchable 2 pin screw terminal to connect one or more alarms,
sirens or lights.
This output is protected against short circuits, has a thermal protection, an overvoltage
and overload protection and current limitation.
Nominal maximum alarm current
Alarm current will be limited to
The Alarm output is a „Low-
Side Switch". Make sure to
have the alarm horn, lamp etc.
connected as shown in the
picture.
–
The terminal "
" has to be connected to GND ( battery –12 Volt )
The alarm device will be connected between the output terminal marked „+" and
battery +12 Volt.
SeaNet-Alarm V1.0
SeaNet-Alarm Users Manual
3.5 A
7.0 A
Page 8 of 19
Advertisement
Table of Contents
