Installation
Location
SeaNet-Alarm is build for interior use and for fully water proteced installation. It is not
designed for outside use.
Since SeaNet-Alarm has LED's and a pushbutton, it is recommended to install it nearby
the chart table or at a place that is easily accessible.
Wiring
SeaNet Alarm will be connected to
SeaTalk Network
•
Power Supply
•
Alarm
•
Power supply
SeaNet-Alarm requires a 12 Volt power
supply. This power supply is isolated
from the SeaTalk network. This galvanic
isolation protects the SeaTalk network
and enables the SeaNet-Alarm to react
to possible failures of the SeaTalk
network – even if SeaTalk power should
be disrupted.
SeaTalk Input
SeaNet-Alarm has a detatchable 3 pin screw
terminal for connection to the SeaTalk network.
Make sure to have the SeaTalk cable connected as
shown in the picture.
SeaNet-Alarm V1.0
SeaNet-Alarm Users Manual
Page 7 of 19