Table of Contents
Advertisement
SeaNet-Alarm Users Manual
When installing or rewiring the system, it is helpfull to see if SeaNet-Alarm is receiving any
SeaTalk data from the network at all. The "logging of raw seatalk data" function helps to
check the wiring. The button
, switches this function on and off.
Please use this function with care. Every single successful received SeaTalk sentence
will transferred to the PC and printed on the screen. This causes a lot of – normaly
unnecessary - data communication. In normal SeaNet-Alarm operating mode it could even
cause loss of an alarm.
Use this function only when newly installing SeaNet-Alarm or when rewiring the SeaTalk
network, to check if the network is operational and if SeaNet-Alarm is receiving SeaTalk
data propperly.
When you see SeaTalk data arriving – please switch this function off again.
Port Status
At the bottom of the main window the "Port
Status" is displayed
SeaNet-Alarm V1.0
Page 11 of 19
Advertisement
Table of Contents
