Table of Contents
Advertisement
Preparations
Connecting the power cord
When all the audio/video connections have been made,
connect the AC power plug to the wall outlet. Make sure
that the plugs are inserted firmly.
The STANDBY indicator lights in red.
Warning
• Disconnect the power cord:
- if you are not going to use the unit for a long time.
- before cleaning the unit.
- before moving the unit.
• Do not:
- connect or disconnect the power cord with wet hands.
- pull the power cord when disconnecting it, as this
may damage the cord and cause fire, electric shock,
or other accidents.
Caution
• Do not alter, twist or pull the power cord, or put
anything heavy on it, which may cause fire, electric
shock, or other accidents.
• If the cord is damaged, consult a dealer and have the
power cord replaced with a new one.
6
Installation
You can select one of the following four installations.
According to your installation, set the DIRECTION switch
on the rear of the unit. When setting the DIRECTION
switch, set it during standby mode. When you set the
DIRECTION switch with the unit powered on, turn the
unit off and on. For the location of the DIRECTION
switch, see page 38.
How to attach the cover
Combine the
connected cables
and power cord,
then position them
on the side of the
unit.
Attach the cover in
order not to pinch the
cables.
To remove the cover
Pull the cover with the mark pushed down slightly.
Horizontal installation
Be sure to set the DIRECTION switch on the rear of the
unit to "1."
DIRECTION
1
2
Advertisement
Table of Contents
