Child Lock; Scan Mode Set (Dvd Deck) - JVC HR-XVC23U Instructions Manual

80
EN
Others Settings
8 RESUME
ON
OFF
8 ON SCREEN GUIDE
ON
OFF

Child Lock

Turn on the TV and select the AV mode.
Slide the TV/VCR/DVD switch to the right.
You can disable the unit's operation.
A
Set the Child Lock.
Press and hold POWER (1) on the Remote for more
than 10 seconds while the unit is turned on. The unit
turns off, and "CL" appears on the front display panel.
To release the child lock, press and hold POWER (1) on the
Remote until the unit turns on.
NOTES:
When the child lock function is in use, keep the Remote out of
the children's reach.
Timer recording programs will be performed even if the child
lock function activated.
When this function is set to "ON", you can use the resume function.
( pg. 45)
ON: You can start playback from the resume point of the
placed disc.
OFF: You cannot use the resume function.
NOTE:
This function is not available for Audio CDs and MP3 discs.
When this function is set to "ON", the unit can display "on-screen
guide" icons or characters which shows the conditions of the unit or
disc.
Scan Mode Set
(DVD deck)
Turn on the TV and select the AV mode.
Slide the TV/VCR/DVD switch to the right.
This unit supports the progressive scan system (eg. 480p*)
as well as the conventional interlaced scan system (eg.
480i*).
If your TV equipped with component video connectors
supports the progressive video input, you can enjoy a
high quality picture by setting the progressive scan mode
to active.
Refer also to the instruction manuals supplied with your TV.
If your TV equipped with component video connectors does
not support the progressive video input, do not change the
scan mode to the "PROGRESSIVE".
* 480p and 480i indicate the number of scanning lines and
scanning format of an image signal.
• 480p indicates 480 scanning lines with progressive format.
• 480i indicates 480 scanning lines with interlaced format.
A
Switch the mode.
During playback or while stopped, press and hold
PROGRESSIVE SCAN on the unit or DVD on the Remote
for more than 3 seconds, to change the scan mode
between Progressive and Interlace mode.
When the Progressive scan mode is selected, the Progressive
mode indicator (
SUBSIDIARY SETTINGS (cont.)
* The default setting is bold in the table below.
) lights up on the front display panel.