Changing Tires
Remove hub cap or wheel cover
with flat end of wheel nut wrench
and loosen wheel nuts slightly. Set
lever on jack to UP position.
Properly position load rest which
engages bumper by moving base of
jack slightly under car and engage
tang of bracket in bumper notch,
then bring jack base back toward
upright position. Check that load
rest is positioned before operating
jack.
NOTE: Base of jack column
should be slightly angled in toward
car
since
it will straighten as car
is
raised.
Jack Operation
After jack is positioned as noted
above, use wheel nut wrench as
jack handle and raise car until tire
clears ground. Remove wheel nuts
and wheel, install spare and
tighten wheel
nuts.
Move jack
lever to DOWN and install hub
cap or wheel cover.
45
REAR
FRONT