Insert Editing - JVC GR-DVL500 Instructions Manual

Display
6w
TC 1 2 : 3 4
Remote sensor
REW
STOP

Insert Editing

You can record a new scene into a previously recorded
tape, replacing a section of the original recording with
minimal picture distortion at the in and outpoints. The
original audio remains unchanged.
NOTES:
1
Lock Button
Power Switch
2
3
4
5
NOTES:
START/STOP
INSERT
PLAY
PAUSE
Before performing the following steps, make sure that
"TIME CODE" is set to "ON" in the Menu Screen
( pg. 32).
Insert Editing is not possible on a tape recorded in the LP
mode or on a blank portion of a tape.
To perform Insert Editing while watching in the
television, make connections (
Play back the tape, locate the Edit-Out point and
press PAUSE (6). Confirm the time code at this point
( pg. 33).
Press REW (2) until the Edit-In point is located, then
press PAUSE (6).
Press and hold INSERT (w) on the remote control,
then press PAUSE (6). "6w" and the Time Code
(min.:sec.) appear and the camcorder enters Insert-
Pause mode.
Press START/STOP to begin editing.
•Confirm the insert at the time code you checked in
step 1.
•To pause editing, press START/STOP. Press it again
to resume editing.
To end Insert Editing, press START/STOP, then STOP
(5).
Program AE with special effects (
to spice up the scenes being edited during Insert Editing.
During Insert Editing, the date and time information
changes.
If you perform Insert Editing onto a blank space on the
tape, the audio and video may be disrupted. Make sure
you only edit recorded areas.
During Insert Editing, when the tape moves to scenes
recorded in the LP mode or a blank portion, Insert Edting
stops ( pg. 61).
51
EN
pg. 34).
pg. 28) can be used