Recording; Basic Recording; Tally Lamp; Power Lamp - JVC GR-DVL500 Instructions Manual

14
EN
Power Switch

Power lamp

Recording

Start/Stop Button
Display
min 90 min
(Now calculating)
0 min
(Blinking)

Tally lamp

(lights while recording
is in progress)
BR I GHT –
180 90
PUSH OPEN Button
Lock Button
During
shooting
2 5
Tape remaining
time indicator
(Approximate)
89 min 3 min
1 min 2 min
(Blinking) (Blinking)
MENU/
BRIGHT Wheel
+
RECORDING
NOTE:
You should already have performed the procedures listed
below. If not, do so before continuing.
Power ( pg. 8)
Grip Adjustment (
Viewfinder Adjustment (
Load A Cassette (
Recording Mode Setting (
1
Press in the tabs on the lens cap to remove it.
2
Set the Power Switch to "
down the Lock Button located on the switch.
Shooting while using the LCD monitor: Press PUSH
OPEN and open the LCD monitor fully. Tilt it upward/
downward for best viewability.
Shooting while using the viewfinder: Close the LCD
monitor.
•The power lamp lights and the camcorder enters the
Record-Standby mode. "PAUSE" is displayed.
3
Press the Recording Start/Stop Button. "
while recording is in progress.
To Stop Recording . . .
.... press the Recording Start/Stop Button. The camcorder
re-enters the Record-Standby mode.
To Adjust The Brightness Of The Display
.... rotate the MENU/BRIGHT wheel until the bright level
indicator on the display moves and the appropriate
brightness is reached.
•If you are using the GR-DVL500, it is also possible to
adjust the brightness of the viewfinder by closing the
LCD monitor and adjusting as described above.

Basic Recording

pg. 10)
pg. 10)
pg. 12)
pg. 13)
" or " " while pressing
" appears