Table of Contents
Advertisement
46
EN
Program
I
N
O
U
T
:
~
1
– –
–
–
–
–
~
2
~
3
~
4
~
5
~
6
~
7
~
8
:
T
I
M
E
C
O
D
E
–
–
–
:
T
O
T
A
L
0
0
0
Remote sensor
FADE/WIPE
EFFECT
EDIT IN/OUT
NOTES:
When choosing a scene, set Edit-In and Edit-Out points so that there is a relatively large difference between
them.
If the search time for an in-point exceeds 5 minutes, the recording deck's Record-Standby mode will be
canceled and editing will not take place.
If there are blank portions before or after the Edit-In and Edit-Out points, a blue screen may be included in
the edited version.
Since time codes register time only as accurately as seconds, the time code total time may not match the
total program time exactly.
Turning off the camcorder's power erases all registered Edit-In and Edit-Out points.
If you select Sepia or Monotone mode from Program AE with special effects, you cannot use the Dissolve or
Black & White Fader. In this case the Dissolve or Black & White indicator begins blinking. Once the next
Edit-In point is registered, the effect is turned off. To combine these effects, use Sepia or Monotone during
recording, then use the Dissolve or Black & White Fader during Random Assemble Editing.
It is not possible to use Fade/Wipe effects and Program AE with special effects during Random Assemble
Editing using a DV cable.
USING THE REMOTE CONTROL UNIT
MODE
Random Assemble
Editing Menu
–
0
PLAY
R.A.EDIT
ON/OFF
CANCEL
SELECT SCENES
4
Point the remote control at the camcorder's remote
sensor. Press PLAY (4) and then press R.A.EDIT ON/
OFF on the remote control.
The Random Assemble Editing Menu appears.
5
If using a Fade/Wipe at the beginning of the scene,
press FADE/WIPE on the remote control.
•Cycle through the effects by pressing repeatedly,
and stop when the one you want is displayed.
•You cannot use a Picture Wipe/Dissolve at the
beginning of Program 1.
6
At the beginning of the scene, press EDIT IN/OUT on
the remote control. The Edit-In position appears in
the Random Assemble Editing Menu.
7
At the end of the scene, press EDIT IN/OUT. The
Edit-Out position appears in the Random Assemble
Editing Menu.
8
If using a Fade/Wipe at the end of the scene, press
FADE/WIPE.
•Cycle through the effects by pressing repeatedly,
and stop when the one you want is displayed.
•If you select a Fade/Wipe effect for an Edit-Out
point, the effect is automatically applied to the
following Edit-In point.
•You cannot use a Picture Wipe/Dissolve at the end
of the last scene.
•When you use Fade/Wipe effects, that time is
included in the total time (this does not apply to
Picture Wipe/Dissolve).
9
If using Playback Special Effects, press EFFECT
(
pg. 43).
10
Repeat steps 6 through 9 to register additional scenes.
•To change previously registered points, press
CANCEL on the remote control. The registered
points disappear, one at a time, from the most
recently registered point.
•If you are not using Fade/Wipe or Program AE with
special effects, repeat steps 6 and 7 only.
(cont.)
1
Hide quick links:
Advertisement
Chapters
Table of Contents
