Selecting the Metering Method
Choose the part of the sensor to use for measuring brightness
and determining exposure.
The sensor meters the brightness in multiple zones. (default setting)
L Multi-
Even in backlit locations, this mode automatically determines
segment
what level of brightness is in which portion and automatically
adjusts exposure.
Metering is weighted at the center of the sensor.
M Center-
The sensitivity increases at the center and no automatic
weighted
adjustment is performed even during backlit scenes.
The brightness is measured only within a limited area at the center
N Spot
of the sensor. You can use this in combination with AE Lock (p.100)
when a subject is too small to obtain a correct exposure.
1
Press the M button in standby mode.
The control panel appears.
2
Use the four-way controller (2345) to select [AE Metering],
and press the 4 button.
The [AE Metering] screen appears.
3
Use the four-way controller (45)
to select a metering method,
and press the 4 button.
The camera returns to the control panel.
• You can also change the setting from the [A Rec. Mode 1] menu.
• Exposure metering is performed immediately after the camera is turned on
or when the capture mode is changed. Set the length of meter operating time
in [3. Meter Operating Time] of the [A Custom Setting 1] menu. Select from
[10sec.] (default setting), [3sec.] or [30sec.].
• In [5. Link AE and AF Point] of the [A Custom Setting 1] menu, you can link
the exposure and AF point in the focusing area when L is selected.
Off
Exposure for multi-segment metering is determined regardless
of the AF point. (default setting)
On
Exposure for multi-segment metering is adjusted according
to the AF point.
AE Metering
AE Metering
Multi-segment
Multi-segment
Cancel
Cancel
MENU
101
4
OK
OK
OK