JVC MX-KC68J Service Manual page 16

3.2.4 Removing the CD servo board
(See Fig.5 and 6)
• Remove the traverse mechanism assembly.
(1) Remove the two screws D attaching the CD servo board
from bottom side of traverse mechanism assembly. (See
Fig.5)
(2) Remove the solder from solder part e of the CD servo
board. (See Fig.5)
(3) Remove the yellow wire from solder part f of the CD servo
board. (See Fig.5)
(4) Remove the white wire from solder part g of the CD servo
board. (See Fig.5)
(5) Remove the CD servo board to upper side, disengage the
hook c to direction of the arrow 1 then turn over the CD ser-
vo board. (See Fig.5)
(6) Solder to short land part j of pickup. (See Fig.6)
(7) Release the lock of connector
row 2 and disengage the card wire. (See Fig.6)
Caution:
• Solder to short land part j of the pickup then disconnect the
card wire from connector
disconnect the card wire before soldering, pickup is make
sure destroyed by static electricity. (See Fig.6)
• When reattaching the CD servo board, connect the card wire
to connector CN601 and then remove the solder of short
land part j of the pickup.
1-16 (No.MB664<Rev.002>)
CN601 to direction of the ar-
CN601 of the CD servo board. If
Solder part e
D
CN601
1
Hook c
CD servo board Traverse mechanism assembly
Fig.5
CD servo board
Pickup
Short land part j Traverse mechanism assembly
Fig.6
Yellow wire
D
White wire
Solder
part f
Solder
part g
1
Hook c
CN601
2 2