Table of Contents
Advertisement
TG80xxC(e).book Page 29 Friday, June 10, 2011 2:06 PM
Registering a unit
Operating additional units
Additional handsets
Up to 6 handsets can be registered to the base
unit.
Important:
L See page 5 for information on the available
model.
Registering a handset to the base
unit
The supplied handset and base unit are pre-
registered. If for some reason the handset is
not registered to the base unit, re-register the
handset.
1
Handset:
{MENU} (middle soft key) y13z
2
Base unit:
■ KX-TG8051 series: page 3
Press and hold {LOCATOR} for about
5 seconds. (No registration tone)
■ KX-TG8061 series: page 3
Press and hold {LOCATOR} for about
5 seconds until the registration tone
sounds.
L If all registered handsets start ringing,
press {LOCATOR} again to stop, then
repeat this step.
L The next step must be completed
within 90 seconds.
3
Handset:
Press {OK}, then wait until a long beep
sounds.
Note:
L While registering, "Base in
registering" is displayed on all
registered handsets.
L When you purchase an additional handset,
refer to the additional handset's installation
manual for registration.
Programming
Deregistering a handset
A handset can cancel its own registration to
the base unit or other handsets registered to
the same base unit. This allows the handset to
end its wireless connection with the system.
1
{MENU} (middle soft key) y131
L All handsets registered to the base
unit are displayed.
2
{r}: Select the handset you want to
cancel. s {OK}
3
{r}: "Yes" s {OK}
4
{OFF}
29
Advertisement
Table of Contents
