EverFocus EDR810H Insruction Manual page 38

NO CHANGE: No change on the display in the main monitor when
motion occurs.
SEQUENCE: Display in the sequence mode when motion occurs
(Full Screen of selected cameras).
ACTIVE CAMERA: Displays the active camera in full screen mode
SUMMARY: Dial Jog to change items in the SUMMARY table. All
alarm's statuses are shown in SUMMARY tables. These tables are for
checking alarm overall statuses, but not for setting.
Press SELECT to Edit (MOTION AREA) Enter a desired channel
and press SELECT to edit a motion area. Please make sure that
MOTION is set as "Enable" before entering the motion detection area.
To test a motion area: Grids will turn into light red from light green
when a motion is detected.
To clear the motion entire area: Press PLAY to clear the entire
motion area.
If you forget the motion grid commands: Press DISPLAY to get
a hint window (shows below) in motion edit mode.
on the call monitor.
In the motion edit mode:
The default motion area of each camera is
entire screen which displays in light green.
Press COPY to start to set an area.
Then press SEARCH to end and enable
the area, or press PAUSE to end and
disable the area.
Dial JOG to select a horizontal
a vertical
ENTER to switch a horizontal
or vertical
Press MENU to quit the motion area edit.
30
or
area, and press
area.