Temperatures; Setting The Weekday And Weekend Cooling Temperatures - Robertshaw 300-224 Installation And Programming Instructions

5. Press the s or t button to adjust the minutes. (Note the minutes are in increments of 10.)
6. Press the PROGRAM button. The heating temperature will be displayed.
7. Press the s or t button to adjust to the desired heating temperature.
B. Repeat Steps 2 -7 for the Day, Evening, and Night program periods. If you wish to use only
the Morning and Night program periods, skip by holding the PROGRAM button in the hour or
minute setting and press the MODE button; 4 dashes will appear.
SETTING THE WEEKEND PROGRAM TIMES
AND HEATING TEMPERATURES
f C
1. After the weekday Night heating temperature has been entered, press the
2. Repeat Steps 2 -7.
iD•ri rr,
3. After weekend Night heating temperature has been entered press the
.PJ
SETTING THE WEEKDAY AND WEEKEND
COOLING TEMPERATURES
'
1. Press the MODE button until COOL is displayed.
r
2. Press the PROGRAM button. MO TU WE TH FR will be displayed along with
nro
0 3. Press the PROGRAM button until the cooling temperature flashes.
P. Ur J 0.
IMPORTANT NOTE: The cooling temperature must be set at least two degrees
higher than the heating temperature.
' R. Parn Thdge. 8J
Kmderkarnack
PROGRAM button. SAT SUN will be displayed.
RESUME button. (Note if the RESUME button is not pressed, the thermostat
will automatically start the program within 15 seconds.)
Note: Since the programmed schedules are the same for both heating and
coaling, you only need to set the cooling temperatures providing you have
already programmed the weekday and weekend heating schedules.
the morning symbol. The starting time will flash.
TI: 201
P7555 -
.
Air Markehng Group LLC
7824782 F . 201 782 7783
- -
5 5
y
Web: www.amga .corn inkipmgarroarn